Short post this time, I was too busy keeping three separate working teams on track for there to be much in the way of decent photos. I thought I had a couple of short vid clips but I guess you have to actually hold the button down on the camera. Next time.
Still fussing with the drive section. There is always a loose connector somewhere. But it is at least drivable now so it makes putting the unit away a bit easier.
Upper segment. This will be the axle that the arms pivot off of.
In the lower of the two "swivel sections" a detail on the pulley drive. On top of the pulley is just another hub/gear combo that came off of the Barby jeep gearbox assembly. A good snug fit but it can be removed if necessary for access.
A better view of the swivel mechanism. Rather a nice bit of work, I do not expect breakage here. And it pivots at a leisurely pace, not likely to smack anyone with the arms.
Imagine arms attached to the upper axle. That would give you a rough approximation of the final shape. Note the slight pivot between sections 2 and 3. Still lots of lights and gadgets to add. Looks like we have one slightly off kilter wheel on the left front, but it runs fine. I can't supervise everything and that one got cranked on securely but off line. I figure a slight wobble in the system will just make it look more humanoid.
Two additional bags of M & Ms were purchased. No more testing done on the dispenser. But we ate half a bag anyway.
No comments:
Post a Comment
I'll be putting comments into "moderator" format for a while. Sometimes they get a bit off topic. I'll post almost all of them even the One Weird Trick Spamsters if they amuse me. I also answer my email at dagmarsuarez@gmail.com